GQ40A Rebar Cutter proper use and safety precautions

1. Pick countertop material should be level and lower cutter, table length can be determined according to the length of the workpiece.
2. Before starting, you should check to make sure no cracks GQ40A Rebar Cutter, turret bolt, solid shield. Then rotate the pulley by hand to check the gear meshing clearance, adjust the cutter gap.
3. After starting, you should first dry run, check after each transmission parts and bearings in normal operation only after the job.
4. machinery does not reach normal operating speed may not cut material. When cutting, use the cutter, the lower parts of the alignment edge grip reinforced quickly put, the operator should stand on the side of force to suppress the fixed blade steel, should be reinforced to prevent the end of the pop-up hurt. It is prohibited on both sides of the blade with both hands holding the steel sub-leaning feeding.
5. Do not cut diameter and strength than mechanical nameplate steel and red-hot steel. Once cut off when a plurality of reinforcement, the total cross-sectional area should be within the specified range.
6. Cut low-alloy steel, replace the high hardness cutter, GQ40A Rebar Cutter plate diameter should be consistent with the provisions.
7. When cutting short material, distance between the hand and the knife should be maintained at 150mm or more, such as hand side is less than 400mm, you should use short steel casing or jig head pinched or folder in prison.
8. The operation is prohibited by hand directly decapitation and remove debris near the cutter. Rebar cutter swing around and around, can not stay non-operators.
9. When they find machinery not functioning properly, abnormal noise or skew cutter, you should immediately downtime.
10. After the job, you should cut off the power, steel brush to remove debris between the cutter, carry out the whole cleaning lubrication.
11. A hydraulic drive front GQ40A Rebar Cutter operation, check that the hydraulic oil and motor rotation direction to meet the requirements. After starting, you should load operation, loose open valve, drain the body of the air cylinder net, before proceeding cut tendons.